-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
tinkergnome 927
The firmware files for UM2+ and older Ultimaker printers are included in the Cura installer, there's no separate download page AFAIK.
If you have Cura installed, take a look at the installation folder ...../resources/firmware. At least that's the case for the Windows version, i don't know if it is the same location in the AppImage?
The firmware file for UM2+ is called "MarlinUltimaker2plus.hex"
If Cura is not installed, you can download the Windows setup file for Cura, open it with an unzip-tool and extract only the file(s) that you need.
Link to post
Share on other sites