Jump to content
faiz5595

Suggestion to improves the adaptive layer height

Recommended Posts

Posted · Suggestion to improves the adaptive layer height

Is there is the way to improve the initial top layer thickness when using the adaptive layer height? This is the beginning before the 1st top layer is printed on the infill 527796528_Screenshot2018-11-0716_13_57.thumb.png.98e72b7b47688f80fb99437576492e93.png

 

On the next layer height of 101, the 1st top layer is printed but the initial thickness base on the layer preview shown the thickness to be 0.05mm which is to thin to support the rest of the top layer .1322371109_Screenshot2018-11-0716_14_23.thumb.png.4320c94ae9e2692daca711982b859082.png

 

Is there any post-processing g-code to make the adaptive layer to ignore the initial top layer or a way to increase the initial top layer layer thickness when using adaptive layer thickness  

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!