Jump to content

UMO+ controller shows nonsense, print stopps

basteluwe

By basteluwe
in UltiMaker 3D printers

 Share

Recommended Posts

basteluwe

basteluwe 1

Posted
Posted · UMO+ controller shows nonsense, print stopps

Hi Guys,

after some days of hard and perfect work recently, my printer unfortunately failed today.

I was printing a 3h job in PLA when after about 75% suddenly the display of my UMO+ controller started to show random symbols and even some nonsense clutter. Short after I noticed that, it stopped printing completely and the head moved to home-position (X,Y).

I use Cura 3.5.1 and have just after that fault updated the UMO-firmware to the actual version (March, 2018). At present I run the same print again while crossing my fingers.

Any ideas as to what can cause a fault like that?

 

Regards from Germany,

Uwe

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...