UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
tinkergnome 927
no way... because.. it depends... ? (mainly on the firmware that you want to use with your mod...)
In case of Marlin firmware one can remove the feeder motor, fans and heaters - basically everything but the temperature sensor.
If all heaters are disconnected one can even safely replace the temperature sensor with an adequate resistor.
And if one is willing to modify the firmware the only limit are the mechanical properties of the device.
Link to post
Share on other sites