UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
It looks like the gcode file on the SD card was not created properly. Did you use Cura to prepare the model for printing?
If you did, which version of Vura did you use? If it is a newer version (version 3.6 is the latest one), then check the „layer preview“. Check the dropdown list in the top right corner of the model preview in Cura. When you switch to layer view, there you can see what the printer would print. There is also a vertical slider. Use it to scroll through the model to see each layer.
Also check the file size of the resulting gcode file. If it is unreasonably small (like below hundred KB or so) - that‘s another indicator that something went wrong with slicing.
Another reason could be that you tried to print very very small model which is too small for the printer to physically print. If you look at the layer view in Cura you would then see that nothing was sliced.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
Nicolinux 288
It looks like the gcode file on the SD card was not created properly. Did you use Cura to prepare the model for printing?
If you did, which version of Vura did you use? If it is a newer version (version 3.6 is the latest one), then check the „layer preview“. Check the dropdown list in the top right corner of the model preview in Cura. When you switch to layer view, there you can see what the printer would print. There is also a vertical slider. Use it to scroll through the model to see each layer.
Also check the file size of the resulting gcode file. If it is unreasonably small (like below hundred KB or so) - that‘s another indicator that something went wrong with slicing.
Another reason could be that you tried to print very very small model which is too small for the printer to physically print. If you look at the layer view in Cura you would then see that nothing was sliced.
Link to post
Share on other sites