UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
Recommended Posts
ultiarjan 1,222
Volgens mij zijn ze inderdaad 1 cm.
De grijze buitenrand is dynamisch en past zich aan afhankelijk van instellingen.
Als je bijvoorbeeld dual-extrusion print zal de rand rechts zich aanpassen omdat je effectieve ruimte kleiner wordt.
Ook b.v. het aanpassen van je "brim" heeft effect. Print je met een bredere brim, dan hou je minder effectieve ruimte over voor je print.
Link to post
Share on other sites