Jump to content
Ultimaker Community of 3D Printing Experts

Temperature Graph in 3.6


flyntm
 Share

Recommended Posts

Posted · Temperature Graph in 3.6

I'm probably just missing it, but in previous versions of Cura I've been able to find real time graphs of the print bed and print head temperatures.  Where are those graphs in Ver 3.6.0?

  • Link to post
    Share on other sites

    Posted · Temperature Graph in 3.6

    Thanks for your reply, but the Monitor tab didn't take me there.  It only lead me to the Maintainance page. But, if I go to  http://192.168.1.???/default.html (the IP address of the printer, it gives me this.  Which is what I was looking for.  Just in case somebody else is searching for it.

     

    Thanks again!

    Screen Shot 2018-12-13 at 8.17.12 AM.png

  • Link to post
    Share on other sites

    Posted · Temperature Graph in 3.6

    Yes, that's right, but there should be also a link in Cura somewhere (around Monitoring page). I cannot check it because I am not at my printer currently.

     

    But the direct access via IP is the fastest way.

  • Link to post
    Share on other sites

    Posted · Temperature Graph in 3.6

    I was wrong, the link I meant was just for the print job queue and I thought you can get from there to the graphs, but it isn't possible. So best you save the shortcut in your browser which is the fastest way anyway.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 12 replies
    ×
    ×
    • Create New...