First layer line

[DivideByZero 0]

Hi,

 

Pretty new to 3D printing, but have had a look and not found mention of this problem (if it is a problem and not by design).

 

I have a Creality CR-10S and am printing with the latest Cura. I print a skirt and then it goes off to print the object, but there is a line printed between the two. You can see it goes from bottom left of the skirt to top right of the object.

 

I thought it was just the print I was trying yesterday, but a new print today is doing the same and I don't recall it doing this before yesterday (pretty sure it wasn't).

 

Any ideas why this would be? Do I just have a setting wrong or something simple?

[burtoogle 515]

Hello @DivideByZero, if you set the combing mode to "No Skin" it should not leave that dribble between the skirt and the model.

[DivideByZero 0]

Thanks, I have found and enabled that option now. Will try it out once my current print has finished.

[DivideByZero 0]

Yep, look like this did the trick, thanks.