Jump to content

Colorfabb White PLA.. eeek not white !!


ian

Recommended Posts

Posted · Colorfabb White PLA.. eeek not white !!

just to let people know.

I received a large 2kg roll of PLA white from colorfabb.

I had a model half completed and needed more pla white.

the original white was from ultimaker and was paper white.. snowy white !

but now i started printing with colorfabbs white yesterday and it comes out like a.. light cream white.. kinda antik look !

so just for information if you buy colorfabb white, it isnt pure white, its granny cream white,...

and now I have to reprint all my model, so it looks all the same... :-(

also note ! the pla flows and prints greats ! but becareful... you will get models that look like DDR antik models !!.. add the dust and sell on ebay antik section ;-)

Ian

 

  • Link to post
    Share on other sites

    Posted · Colorfabb White PLA.. eeek not white !!

    then you should have ordered the blueish-white....... :eek:

     

    to be honest. I was also offered the blue white... but stupid me... I thought blue white would be a tiny bit blue... so i went for the normal pla white.. not thinking it would look like a old pair of granny underpants !

    Ian

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 18 replies
      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
    ×
    ×
    • Create New...