Jump to content

Bed not raising at all when printing via usb - Ultimaker 2


Recommended Posts

Posted · Bed not raising at all when printing via usb - Ultimaker 2

I am having an issues where when I try to print from Ultimaker Cura (3.6.0) the build plate does not raise at all, it just starts printing immediately. Also the extruder and build plate are not pre-heating, it again just starts printing immediately when I click "Print via USB". If I save the file to an SD card from within Cura and then insert and print from the card, it prints perfectly fine. Can anyone help with this? I have tried looking around and have found no solutions.

 

Thanks!

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.9 stable released!
        Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements.  Check out the rest of this article to find out the details on all of that and more
          • Like
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Heart
          • Thanks
          • Like
        • 4 replies
    ×
    ×
    • Create New...