Jump to content
Hooseirnation1986

Cura only creating partial gcode prints

Recommended Posts

Posted · Cura only creating partial gcode prints

I am new to the community just got my printer last week. The test prints that were pre-loaded printed just fine. I am now trying to do my first project by loading the file into Ultimaker Cura, after I perform the splicing and save the file to my SD card I performed a couple of prints all being incomplete. I found the file actually said the print was finished and 100 percent completed. I moved onto checking the file after saving the gcode file to the SD card and found only a portion of the model was being saved. I have tired multiple different prints all with the same outcome. I am now completely lost on trouble shooting. 

 

I have uninstalled Cura and reinstalled with no luck and have even changed versions of Cura.

image.thumb.png.83f9c916168462504cb790613243e474.png

 image.thumb.png.b1efa1a7ac7040abe4ac43bf6b7e3caa.png

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!