Firmware: 5.1.8 available

[HarrySatt 0]

Version 5.1.8 from 2 January, 2019 available. Tried to update to this release but still on 5.1 Oct. 2018 after finishing.

What am I doing wrong.

Regards, Harald

[Shadowman 53]

43 minutes ago, HarrySatt said:

Version 5.1.8 from 2 January, 2019 available. Tried to update to this release but still on 5.1 Oct. 2018 after finishing.

What am I doing wrong.

Regards, Harald

Relax 

 

I update over the air and every time it begins the process and then seems to hang. I have to reboot the S5 and initiate the update a second time and then it works.

 

I hope that you experience the same results.

 

Please update this thread.

 

Thank you 

[HarrySatt 0]

No. No acceptance of new update on ULTIMAKER 3 for 5.1.8 if the bits are 5.1.8.

 

Regards, Harald

[Smithy 1,146]

1 hour ago, HarrySatt said:

No acceptance of new update on ULTIMAKER 3 for 5.1.8 if the bits are 5.1.8.

 

5.1.8 is for the S5 only.

[UltiSandra 2]

Please don't update Ultimaker 3 with 5.1.8 as this firmware version is S5 only. 

[HarrySatt 0]

Ooops! I get that link if I select S3 on firmware page. Thanks for telling me. Should be removed on landing page for firmware update.

Regards, Harald

[Shadowman 53]

Good information shared

 

Thank you