Jump to content

Recommended Posts

Posted · Power Outage

What are best practice to beat a power outage?  Keep unit on a 1-2 hr battery backup, pause print until outage is resolved?

 

thanks

Share this post


Link to post
Share on other sites
Posted · Power Outage

You will always see the layer where you have paused the print, not bad but you will see it. 

So if you have a backup battery for about 2 hours I would let the printer printing and just in case it takes longer, pause the print near the end of the battery.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!