Cura 4.0 Monoprice Ultimate help?

[DonaldNaegele 0]

Cura 4.0. Defaults using Wanhao Duplicator 6 (since there is no Monoprice Ultimate). The brim was onion skin thin or missing in parts. PLA filament. Suggestions? I'm a Simply3D person but want to use Cura from now on.

[burtoogle 516]

Hello @DonaldNaegele, if the brim is too thin, that suggest that the nozzle is too close to the bed on that first layer.

[LucianoLeoi 1]

Hi @DonaldNaegele , try adjust the first layer height to 0.25 or 0.3. Worked for me.