3 minutes ago, gr5 said:First of all - it's 90% most likely that the bed is too low. You can confirm by pushing up gently on the bed as it prints the bottom layer.
Secondly - you really need to watch this video. It's packed with details about getting parts to stick very very well and... well and why these tricks work.
Thanks, giving the video a watch, however I have releveled the bed many times, with different heights (using the 0.15mm calibration card, and using the 'touch the nozzle to the build plate, then back off lightly', and a things in between) and I think the latest bed level is right where I want it.. the initial layer looks smooth with no excess material, no rounding, and no transparency.... until of course, curling/warping happens and the whole thing fails.
Recommended Posts
gr5 2,224
First of all - it's 90% most likely that the bed is too low. You can confirm by pushing up gently on the bed as it prints the bottom layer.
Secondly - you really need to watch this video. It's packed with details about getting parts to stick very very well and... well and why these tricks work.
Link to post
Share on other sites