What? Dust in the z screw? Dust in the filament? I don't get it. I thought the pattern was regular. I guess maybe the problem doesn't show up in the photo? Or maybe the entire part was underextruded?
What? Dust in the z screw? Dust in the filament? I don't get it. I thought the pattern was regular. I guess maybe the problem doesn't show up in the photo? Or maybe the entire part was underextruded?
The problem was dust on the filament. The problem manifested in horizontal lines, that seemed regular. Probably the dust on the filament was so thick, the clogs happened at regular intervals.
Recommended Posts
flydive 0
So the problem appeared to be dust. Adding a simple dust filter resolved the issue.
Link to post
Share on other sites