UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I think what this means is you are printing too fast. The geometry changes in that area such that there are more walls, causing a greater average quantity of filament needing to be melted and pushed out. In the other layers you’re probably right at the edge of what your extruder and hot end can deliver. When you get to the more complex area, it just can’t keep up.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
johnse 31
I think what this means is you are printing too fast. The geometry changes in that area such that there are more walls, causing a greater average quantity of filament needing to be melted and pushed out. In the other layers you’re probably right at the edge of what your extruder and hot end can deliver. When you get to the more complex area, it just can’t keep up.
At least, that’s my guess.
Link to post
Share on other sites