Layer BRIM

[luigi80 0]

Hi, in cure 4.3 there is not the possibility to add layers in the BRIM? I would like to increase adherence to the plan, but use RAFT. Thanks.

[luigi80 0]

 without however using RAFT

 

[Smithy 1,146]

If you mean the brim width, then this is possible. Just use the search field to get the setting:

 

[luigi80 0]

Hi, sorry I'm talking about the possibility of adding layer height to the brim and not brim lines. Adding layers I can give more support.

[Smithy 1,146]

No, as far as I know the brim is only a single layer and has the height of the initial layer.

[luigi80 0]

Thanks.