How to stop retraction for infil ?

[tonycstech 5]

Infill at 20% will have too many retractions taking place.

Is there a way to limit the amount of retractions for infill only ?

I cannot limit retractions for walls because before each wall approach, retraction MUST take place.

For infill, its not that critical because its inside and stringiness or even partially dry areas are not problem because its inside the mode.

 

 

Is there any way to achieve this ?

[burtoogle 515]

If you use gyroid infill with the connect infill lines option enabled you will not get many retractions and also you can get away with lower density, e.g 15% compared to 20.