Happy to...
Thanks, burtoogle, that's fixed it.
It hadn't occurred to me that an Infill setting would affect the Shell. I'd assumed Shell was king. So much still to learn 🙂
Well, I think that setting was possibly in the shell category before and they moved it? (might be wrong about that). I agree that it doesn't make sense to have it in the infill category as it's not affecting the infill but the skin.
- 1 year later...
Is there no feature/setting in cura to set a minimum shell thickness (which is then meassured not only horizontaly = current wall thickness setting or vertically = current top/bottom layer setting, but also in all other directions).
Technically, cura would just have to put a litte sphere (with a radius of the minimum shell thickness setting) on every outer point of the part. All possible spheres have to lie within the walls or top/bottom layers.
Example with 3 outer wall lines in the spot of the corner:
Recommended Posts
burtoogle 516
Hello @weevil, could you please save the project file (File -> Save) and attach the .3mf file to this thread so we can check the model and settings. Thanks.
Link to post
Share on other sites