cura 4.x on ender 3 no longer centered on bed

[jvanryn 0]

I have been trying to ignore this issue... BUT...  ever since like 4.1  I have noticed that the purge line is no longer on the very left edge of the bed.  Along with that all prints are now starting off to the right of center by a couple MM. 

 

I can find no way to adjust this.  I have changed my bed size from 220 to 235 and non of it makes a difference. 

 

This seemed to have started around the time of the addition of that mod for cura and enders. 

[Spandex_Spatula 1]

Same here. I would suggest going back to the legacy settings or switching slicers at this point.