UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
So from the image it appears your model isn't sitting flat. One circular area is touching the bed but the rest is not - it is maybe 0.00000000000001mm higher.
You could fix it in cad but a faster fix is in cura. Go to menu "preferences" "config cura" and go to "general" tab and uncheck "automatically drop models to the build plate".
Then use the move tool and click on the part and set the Z value to a negative value. Try -0.2mm to start then move that value closer to 0mm until it slices "wrong" again and go back. If you are lucky you only have to shave off 0.1mm of the bottom of the part to get it to print "correctly".
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
gr5 2,192
So from the image it appears your model isn't sitting flat. One circular area is touching the bed but the rest is not - it is maybe 0.00000000000001mm higher.
You could fix it in cad but a faster fix is in cura. Go to menu "preferences" "config cura" and go to "general" tab and uncheck "automatically drop models to the build plate".
Then use the move tool and click on the part and set the Z value to a negative value. Try -0.2mm to start then move that value closer to 0mm until it slices "wrong" again and go back. If you are lucky you only have to shave off 0.1mm of the bottom of the part to get it to print "correctly".
Link to post
Share on other sites