Jump to content
Ultimaker Community of 3D Printing Experts

support interface pattern


Recommended Posts

Posted · support interface pattern

I am running Cura 4.3 on a two extruder machine. Extruder 1 is used for the model, extruder 2 is used for support.

I am trying to change the support interface pattern. If zig zag is selected, rather than the normal 45 degree pattern I get from every other zig zag selection, the pattern is 90 degree rotated (or an additional 45 degrees).

Is there a setting someplace that I am not aware of that regulates the angle used in zig zag patterns ?

The zig zag angle also doesn't seem to alternate orientation like it does on any other zig zag pattern.

What am I missing ?

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 14 replies
    • Create New...