Part Cooling Fan not turning on since 4.4.1

[shuhdonk 0]

Hey all, since upgrading to latest cura my parts cooling fan is not turning on at layer 2 anymore (or ever) until I manually turn it on either in octoprint or on the printer itself.  I have it set in cura to run at 100 percent starting on layer two but its no longer working on either of my printers I use cura with (cr10s pro and sovol sv01).  Slicing on two different computers gives same results to either printer.. ideas what may be the problem?

 

Thanks!

[burtoogle 514]

Check in the machine settings dialog that the cooling fan number on the extruder tab is correct. For almost all printers it should be 0.

[shuhdonk 0]

Its funny you mention that, I was literally just looking at that and wondering.. will test once I am done with these prints... thanks.