Hello Bas,
Thank you for your reply . I now feel more sure about what to do . I am preparing a new print on this moment with the settings you mentioned . These are a bit more extreme than what I tried before, so this could be positive .
This is print is estimated to take 21 hours, but the lower part might be visible by tonight . I will let you know the result,
Dankjewel !
Aum.
Recommended Posts
baasb 6
Hi Aum,
I think you should try lower a temperature. 210°C is already 'fairly hot' for most PLA so try 205 or even 200 with a lower print speed and high fan speed.
You can choose a different speed for outlines and infill. Let's say 30 mm/sec for outlines and 60 mm/sec for infill (at 0.1 mm layer hight). So you keep the speed but increase surface quality.
Hope this solves your issue! Groet, Bas
Link to post
Share on other sites