Max voltage to run UM1 v1.5.7 electronics

[that_guy 0]

I'm looking to upgrade my PSU to something a bit beefier to run my (planned) heatbed and a (possible) second extruder.

350W should cover it?

I have 2 options - 15V or 24V.

Because of my location, shipping costs for anything international makes them prohibitively expensive

I know the printer will run off 15 but I'd prefer to go as high as I can.

Will the 24V fry my board?

 

[gr5 2,070]

Will the 24V fry my board?

 

yes. But you can replace just one part and it will be fine with 24V. This was discussed just today in google groups. There are some very smart ultimaker owners over there:

https://groups.google.com/forum/?hl=en#!forum/ultimaker