Jump to content

Cura 4.5: Wrong Holes


Recommended Posts

Posted · Cura 4.5: Wrong Holes

Hello,

after a few misprints, I found, that cura 4.5 made wrong holes, if a cube (openscad) was used to make a hole.

All holes are only some mm from each edge!

1st pic: from openscad

2nd pic: wrong name

3nd pic: Cura prepare

4nd pic: Cura preview, you can see what's going wrong.

 

openscad.jpg

cura 4.5 preview.jpg

cura 4.5 prepare.jpg

cura preview.jpg

  • Link to post
    Share on other sites

    Posted (edited) · Cura 4.5: Wrong Holes
    15 minutes ago, EberleAl said:

    Hello,

    after a few misprints, I found, that cura 4.5 made wrong holes, if a cube (openscad) was used to make a hole.

    All holes are only some mm from each edge!

    1st pic: from openscad

    2nd pic: wrong name

    3nd pic: Cura prepare

    4nd pic: Cura preview, you can see what's going wrong.

     

    openscad.jpg

    cura 4.5 preview.jpg

    cura 4.5 prepare.jpg

    cura preview.jpg

     

    cura preview 90°.jpg

    Edited by EberleAl
    5th pic
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    ×
    ×
    • Create New...