Hello Burtoogle,
It works ! Great ! Thank you for this help, little for you but high for me ...I understand better and better the rights in Linux ...
Bye !
Michel
Hello Burtoogle,
It works ! Great ! Thank you for this help, little for you but high for me ...I understand better and better the rights in Linux ...
Bye !
Michel
HI
I have an Acer Chromebook and I need to connect to my 3D printer. How can I use this same software to be compatible with the 3D printer?
You dont.
UltiMaker Cura does not officially support running on Chromebook hardware or operating system.
Operating System Requirements here: https://support.ultimaker.com/s/article/1667337917781
Thanks for the information.
Recommended Posts
burtoogle 516
Hi, you don't need to install it as such, you only need to make it executable. To do that on the command line do
cd DIR_WHERE_FILE_IS_LOCATED
chmod +x Ultimaker_Cura-4.5.0.AppImage
You can probably also do it from your filemanager (perhaps, right click, properties?)
Once the file is executable you an either execute it from the command line or from the file manager.
Hope this helps!
Link to post
Share on other sites