XY - Offset

[hesinem550 0]

Hello,

I own a heavily modified Hesine M550 and I try to optimize my print quality.

In the past I used Slic3r and Cura. As I read very promising reviews of Ultimaker Cura, I installed v.4.5.0

Now I have a problem, which I tried to solve by searching the Web and this Forum for a good afternoon.

At G28 X0 Y0 the Nozzle is X-32, Y-5 from 0/0 of the bed (left/front).

In Slic3r and Cura I can enter this values and the object is placed correct in Octoprint, but now it is misplaced (see image).

It seems, that I am to dumb to find this setting in Ultimaker Cura.

 

Greetings and thanks a lot for any help

Peter

[hesinem550 0]

Hello,

an additional Information: Hesine M550 is about the same as Anet A8 or Zonestar P802M

 

Thanks, Peter