Cannot rotate infill lines?

[men8ifr 1]

I would like to rotate the infill lines in this example

 

I try values in the 'infill lines direction, 0,45,90 etc but this has no effect? 

 

How can I change the direction of the infill? 

[burtoogle 514]

Comment deleted.

Edited April 3, 2020 by burtoogle
I didn't understand!

[men8ifr 1]

It is listed as infill... 

[burtoogle 514]

Yes, I was confused because I thought you were referring to the blue layer, I couldn't see the infill in the walls (crap eyes).

 

[men8ifr 1]

I tried the top/bottom direction just in case that does nothing either...

[BenMarolt 0]

I can't read the angle in the screen shot, for some reason the image is very low resolution for me, but I have run into this, or something similar before. It didn't seem to matter what number I put in Infill Line Direction and Cura seemed to just ignore it. When I had a sequence of different line directions, I had previously seen it end up in square brackets for top and bottom line direction, like [0,30,60], and this always worked, so I tried it a sequence of one direction, and that has been reliable for lines, zigzag, grid, and triangle. It might work with the other patterns, too.

 

Long story short - the fix for me was to put the number of degrees for the rotation within square brackets. For example:

  15

... generates the same result as leaving the direction blank, but:

  [15]

...rotated the pattern direction by 15 degrees.

 

I hope this workaround works for you!

Edited April 4, 2020 by BenMarolt

[men8ifr 1]

Thankyou Ben, this was indeed the problem