57 minutes ago, dtose said:Would it be possible to include initial layer flow in this plugin?
Sure. See Extentions -> Material Settings -> Configure Material Settings
58 minutes ago, dtose said:Is there some way to get the previously saved 75° back to the variable it was at the beginning
Yes, by "removing" (reverting) the setting in the Print Settings tab on the Materials pane of the preferences, with the Material Settings plugin installed.
Recommended Posts
ahoeben 1,981
You can do that by installing the Material Settings plugin. It should show you a "revert arrow" if you change a value on the Print Settings on the Material preferences pane.
Yes, but only by editing text files, and not for values set per material in the Materials pane of the preferences.
Link to post
Share on other sites
dtose 3
Hello ahoeben,
thank you for your help.
As with your octoprint-plugin, this plugin seems pretty helpful to me. Would it be possible to include initial layer flow in this plugin?
I like to change flowrates for the first layer. So if I were able to adjust all the material related settings in the material tab / your plugin, it would be a very comfortable solution.
Maybe I didn't state my intent very good. What I meant was:
Is there some way to get the previously saved 75° back to the variable it was at the beginning (linked to build plate temperature).
It might seem like a minor thing, but I'm pretty new to printing and still experiment a lot with the settings. So it happens to me from time to time that I forget to revert changes before saving the profile. That results in having to create an entirely new one to get the links to other settings back.
Oh, and what I wrote in my first post isn't entirely correct. Just quitting Cura won't save the changes finally. I can revert from there.
Best regards,
dtose
Edited by dtoseLink to post
Share on other sites