Jump to content
Ultimaker Community of 3D Printing Experts

Breakaway support


Luridii
 Share

Recommended Posts

Posted · Breakaway support

Hello,

I was printing with Tough PLA Black and White Breakaway support material and I noticed that the Breakaway wasn't attaching to the Tough PLA. I had all of the correct print settings. The official Ultimaker website and others list no incompatabilities between the two materials. How can I fix this issue?

I suspect the the gradual slope of my print and the 0.1mm layerhight is causing the problem. 

Feedback would be apreceated.

 

Thanks

20200417_155045.jpg

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
        I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot! 
          • Thanks
          • Like
        • 4 replies
      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 12 replies
    ×
    ×
    • Create New...