Min temp. error on PrintCore - ER13

[JulioLloret 0]

Hi guys,

 

I am new, my UK3 has less than a week and I am getting the the error "Min temp. error on PrintCore  - ER13".

The filament is staked in the printcore and it is not clear what to do now. 

I need some help here please.

 

Thanks in advance

[DarRAven 4]

Be sure that environment that you are printing is not very cold if it is optimal but these problems continues it is probably a problem with the circuit located at the back of the print core. In this case the print core cannot be repaired and must be changed.

Edited May 2, 2020 by DarRAven