Cura slicing question

[umhvw 0]

Hi, If I draw a small box of x=10mm by y=20mm by z=20mm high with Sketchup with a layer thickness of 0,1mm set in Cura then Cura slices it into 18 slices where I should expect 20 slices?

[gr5 2,269]

Well 20 divided by 0.1 is 200.  So something is wrong with one of your numbers.

 

Anyway you should know that typically the bottom layer is about 3 times thicker so having 2 slices fewer than expected sounds perfect.  Look for "initial layer height" or something like that.

[umhvw 0]

Yes! Thats the problem. It's part of the Quality header. I did not realize that there are soooo many settings...

Thanks.