Huh... this is complicated. It happens with any setting as long as there is more than 0 infill walls and more than 0 gradual infill steps. I have tried infill from 0.1% to 80%, step size from 0.5 to 10mm and step count from 1 to 10.
Printed part on those photos was at 50% infill, 2 steps of 1mm (and 0, with no other changes at all).
If I set it to 10 steps I get ten times overprint on the outer infill wall and 8.5 extra infill walls next to it.
Here, I have recorded how it simulates it (and also prints) with ten steps. pay attention how many times it mover over the outer perimeter before starting to print internal ones:
I doubt it is specific to me, so I guess it should be very easy to replicate...
P.S.: Situation with excessive internal infill walls is not as bad with only 2 steps
Recommended Posts
gr5 2,224
There are 3 settings that affect gradual infill. We need to know what you set all three to. Please read this post - CLICK ON MY ICON JUST BELOW TO GET MY REPLY - DON'T CLICK ON THE ENTIRE TOPIC (you'll get that anyway but it will jump to my post).
Link to post
Share on other sites