Jump to content

Printer suddenly stops


Recommended Posts

Posted · Printer suddenly stops

I have an Ultimaker 2+ and I've been using it on and off.

Over the last couple of weeks I've run into a few instances where the printer just stop in the middle of a print.

One time I was next to the printer and in that case the printer stopped and the print bed just started to drop down (like it was completely exhausted)

Other times the printer just stopped completely with the printer bed staying lifted and the nozzled "glued" to the cooled down 3D print.

I'm pretty sure that the G_code is OK because the last time it happened was a repeat print of a print I did earlier in the day and it printed without any issues.

 

Anyone have any suggestions what this could be? 
 

 

Thanks in advance

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
      • Ultimaker Cura 5.6 stable released
        Cura now supports Method series printers!
         
        A year after the merger of Ultimaker and MakerBotQQ, we have unlocked the ability for users of our Method series printers to slice files using UltiMaker Cura. As of this release, users can find profiles for our Method and Method XL printers, as well as material profiles for ABS-R, ABS-CF, and RapidRinse. Meaning it’s now possible to use either Cura or the existing cloud-slicing software CloudPrint when printing with these printers or materials
        • 48 replies
    ×
    ×
    • Create New...