UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Most likely your short belts need tightening. Undo the four screws holding the stepper motors in place, push down fairly hard on the motor and screw the screws back in tight.
Also check that the set screws on your pullies are tight so that the pullies cannot move.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
IRobertI 521
Most likely your short belts need tightening. Undo the four screws holding the stepper motors in place, push down fairly hard on the motor and screw the screws back in tight.
Also check that the set screws on your pullies are tight so that the pullies cannot move.
Link to post
Share on other sites