Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up

Ulitmaker s5 and 0.6mm Nozzle

Recommended Posts

Posted · Ulitmaker s5 and 0.6mm Nozzle



I have an Ultimaker s5 and recently purchased the 3d Solex Hardcore 0.6mm with Sapphire tip. Primarily for printing with copperfil. But, thought I'd try it with standard PLA prints to see if I can increase the speed of some prints vs 0.4mm nozzle and strike a balance between quality and speed.


My question is, am I best off using the CC 0.6 default settings in cura  as my baseline?




Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...