Trouble setting Cura 4.6.1 and Ender 5

[j_p 0]

Hi everyone,

 

I have some difficulties to configure Cura 4.6.1 to print correctly on an Ender 5.

As you can see in the image, when I use the Creality Silcer software I get a pretty fine print. I tried to copy and paste the setting from Creality Silcer to Cura but the result is disappointing with the top (body is OK).

 

 

I tried to change the temperature, shell and travel speed without any success. My Cura config is:

 

 

Does anybody have any idea on which parameters should be changed to correct this problem?

 

Thank you

[Cuq 205]

1) Flow 

2) Acceleration / Jerk

3) Print speed looks too hight for a ender 5 ... 80 mm/s is on my point of view on the upper limit

[ghoster 0]

Hi. I am a novice so not sure of this but is your line width the same as the nozzle width in which case it is asking for the maximum rate to be deposited.