-
Our picks
-
Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
SandervG posted a topic in Official news,
I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot!-
-
- 4 replies
Picked By
SandervG, -
-
New here? Get ahead with a free onboarding course
SandervG posted a topic in Official news,
Hi,
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.-
-
- 12 replies
Picked By
SandervG, -
-
Recommended Posts
Smithy 1,088
It is just a signing issue you can easily solve.
Open your Finder, go to the Application folder and search for Cura there. Then RIGHT click on Cura and select Open. A warning message comes again, but you can override it now.
After you have opened Cura once with that method, you can start it normally in the future, your Mac remembers that it is ok to start the application.
Link to post
Share on other sites