UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I’m going to guess you have downloaded but then on install it’s saying it’s being blocked and to contact the dev. If so all you need to do it the following.
After you have tired to install Cura go to System Preferences, click Security & Privacy, then click General and you should see a Open Anyway button, just click that and then open as normal Cura.
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
Carla_Birch 116
Hi,
I’m going to guess you have downloaded but then on install it’s saying it’s being blocked and to contact the dev. If so all you need to do it the following.
After you have tired to install Cura go to System Preferences, click Security & Privacy, then click General and you should see a Open Anyway button, just click that and then open as normal Cura.
Edited by Carla_BirchLink to post
Share on other sites