Jump to content

Connection lost of S5 from DF and CURA

Roli4711

By Roli4711
in UltiMaker Digital Factory

 Share

Recommended Posts

Roli4711

Roli4711 11

Posted
Posted · Connection lost of S5 from DF and CURA

Hi

 

With the newest Firmware version I have the same issue like before. A lot of connection interupts. My S5 (Pro Bundle) is connected through an internal and proper 1Gb/s network. But often, there is no connection. Normaly, this interupts takes about 10-20 seconds. But also I have interupts for hours and longer.

 

And as I say: It's from the WebPage UM Digital Factory and from the CURA (4.6.1)

 

Thanks for reply

Roland

 

image.thumb.png.0a8340b4be03127c021c083ab853c184.png

image.thumb.png.95ac7cb691f02dc2db9e98516c8ad29a.png

    • Link to post
    Share on other sites
    ctbeke

    ctbeke 133

    Posted
    Posted · Connection lost of S5 from DF and CURA

    Hi,

     

    Would you be able to extract the logs from the printer to a USB drive and upload them here (or send them to me in a private message)? Then I can hopefully see what's going on.

     

    Chris

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 16 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...