S5 axle alignment instructions has a broken link

[matto 0]

This link https://ultimaker.com/en/resources/19953-aligning-the-axles jumps to a page about "Installing the Extrusion Upgrade kit for the Ultimaker 2".  Can this be fixed?  I would like to align one of my printer axles which a slightly askew.

[Enigma_M4 101]

Hi,

this link is a big improvement to the situation before, when the instructions for axle alignment were totally gone.

Just download the attached PDF of your preferred language and follow the instructions in chapter 3 (page 20 and following).

The calibrating sticks can be found on youmagine or thingiverse. For the S5 you need two sets of different sizes referring to the different axle sizes of the S5.

Regards