Jump to content
UltiMaker Community of 3D Printing Experts

Display/communication issue on boot


Recommended Posts

Posted · Display/communication issue on boot

I’m new to the forum so sorry for not posting in the proper thread.  I have a new s5 pro bundle.  Prints well.  The display does not get past “Ultimaker S5” or the “working” circle.  It will accept jobs from cura although occasionally cura cannot see the machine.  If I pull the plug and wait a minute or 2 it will boot properly once.  After turning off it will not boot properly again unless unplugged and plugged back in.  I can provide logs.  Thanks

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now

    • Our picks

      • New here? Get ahead with a free onboarding course
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
        • 14 replies
    • Create New...