Jump to content

Speed Settings


tk9851

Recommended Posts

Posted · Speed Settings

Hello all,

 

I am having an issue with Cura 4.7, where no matter what speed settings I enter, my projects are sliced to print at 100 mm/s. Has anyone encountered this issue?

 

Thanks in advance

  • Link to post
    Share on other sites

    Posted · Speed Settings

    OK, I assumed you were trying to push it over 100mm/s.....

    How do you know its staying at 100?

    I would try another slicer, if you have the same results in another slicer, then it is your firmware

    If the other slicer slows it down, then the problem is in the gcode that Cura is producing

  • Link to post
    Share on other sites

    Posted (edited) · Speed Settings

    I have been using Cura with Octoprint. I sliced the stl to an SD card and printed directly from that and was able to verify that it had been sliced at 100 mm/s. I have used Prusa slicer, and did not have that issue, which leads me to believe that it is an issue with my Cura settings, though I haven't been able to find anything that would cause that.

    Edited by tk9851
  • Link to post
    Share on other sites

    Posted · Speed Settings

    Did you sort anything out for the speed settings not making it to the Cr-6 SE? I'm having precisely the same issue and must change speeds manually on the printer.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
      • UltiMaker Cura 5.7 stable released
        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 26 replies
    ×
    ×
    • Create New...