Why is is doing this ????!?!

[Oystervjh 1]

https://www.dropbox.com/s/p6ww1utkhmra85f/Ultimaker .MOV?dl=0

[UlrichC-DE 109]

Sounds familiar.
About 33 years ago (maybe there were more) I also disassembled a lot of things.
Completely by accident and couldn't get it back together. 😅

 

Turn the lever. It is wrongly attached in your video.
Also the cover has to be on it. The feeder doesn't work without it.

[UlrichC-DE 109]

Forgot to mention. Normally the lever places the ball bearing with the filament against the tooth roller.

As far as I remember. Do not unscrew it very often. I have controlled myself in this respect.

 

Good luck

[Oystervjh 1]

15 minutes ago, UlrichC-DE said:

Forgot to mention. Normally the lever places the ball bearing with the filament against the tooth roller.

As far as I remember. Do not unscrew it very often. I have controlled myself in this respect.

 

Good luck

 

31 minutes ago, UlrichC-DE said:

Sounds familiar.
About 33 years ago (maybe there were more) I also disassembled a lot of things.
Completely by accident and couldn't get it back together. 😅

 

Turn the lever. It is wrongly attached in your video.
Also the cover has to be on it. The feeder doesn't work without it.

Can you take a video or email me at oysterv.j@gmail.com?

[UlrichC-DE 109]

Unfortunately I cannot record a video right now.
The printer is at another location.

 

On the center of the manual-lever is an eccentric (red arrow) that pushes the bearing-lever.
You can take out the bearing-lever under the bearing and turn the manual-lever.

 

I found a picture here in the forum.
That looks better.

Edited September 19, 2020 by UlrichC-DE
Something wrong. Too many levers

[Oystervjh 1]

Yeah that part broke off on my lever

[UlrichC-DE 109]

You have to rotate this part (red arrows from your video)