Extraneous travel moves in Cura 4.7.1

[greenlegoman08 0]

Sometimes when I slice a part in Cura, it makes the most s travel moves and I can't seem to figure out why. I have attached a photo of an example of this problem. Does anyone know how to fix this or why this happens? I have tried changing combing mode settings but none have affected it. Any help is appreciated.

[GregValiant 1,288]

Until someone shows up who knows what they're talking about - look under "Cooling" at Minimum Layer Time and Lift Head.  You have a small cross-section there and Cura may be letting each layer cool sufficiently before continuing to the next layer.

[greenlegoman08 0]

Sadly that did not seem to fix the issue, even when I set the minimum layer time to 0.

[greenlegoman08 0]

It seems to do it at the start of a new layer.

[GregValiant 1,288]

You've probably been looking at all the settings but is the prime tower enabled?  Or a wipe or nozzle clean or a plug-in?

Edited September 25, 2020 by GregValiant

[greenlegoman08 0]

Thank you so very much! It was "Wipe nozzle between layers" that was causing the issue. Thanks so much for the help. 🙂