Jump to content

Triangle Printing before project


starwarsmasterq

Recommended Posts

Posted · Triangle Printing before project

Good Morning,

        When I use Ultimaker Cure 4.7, before my print start I get a triangle that forms and I have to peal it off to have my actual print. If I don’t remove it then it will mess up my first layer. Has there been a patch in the program or a change ican make in the G-code or anything to where that does not happen and it just does the line on the far left edge and it does not get in the way of my first layer?

 
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
        • 3 replies
    ×
    ×
    • Create New...