Tips on Supports

[jasonwstanley 0]

Hello,

 

I'm very new to this.  I'm learning Fusion 360 and made this little guy.  I'm aware that the model might not be easily printable but I wanted to print it, if for no other reason than to justify the hours I put in to it.  I downloaded the custom support plugin and I've watched a few videos, but I was wondering if anyone had feedback on where to place supports or if there were some good tutorials on it?  I am using an Ender 3 Pro with PLA if it helps.

Timber Test.stl

[Framar 38]

Nice model. Support position is tricky. Sorry I don't have any tip for you.