Strati di supporto

[Michele1982 0]

Ciao, per una prova che devo effettuare,

devo riempire un supporto utilizzando il riempimento al 100%

ma che sia sempre estruso dalla stessa direzione

e no che ogni volta si mette parallelo al riempimento precedente.

Come posso fare?

[GregValiant 1,319]

That is an interesting project.  I'm not sure how good the translation to English works.

I tested with a 25x25x25 cube.  I can get close but Cura wants to make the trip as short as it can.  That means extrude a line up, move over, extrude down, move over, extrude a line up, etc..

Every layer looks just like this.  No walls, no floor, no top, just infill

 

If the project needs to:

Extrude a line up, move over, come back, extrude a line up, move over, come back, extrude a line up, etc you will have to fool any slicer into doing that.  It is totally inefficient and goes against the programmers intent.  I am not saying it can't be done, but it may require some programming skills.

 

I won't do the test for you, but playing with the settings in a slicer you should get to the photo above.  Here is the big clue    [ ]

 

Good Luck!

Greg (from Orvieto) Valiant